Product Range
PACE Convective systems are ideal for removing Surface Mount Components as they leave little residual solder on the PCB. They are also appropriate for installing leaded components with solder paste and for installing components without visible leads, such as BGA's, MLF's, LGA's, and LCC's. PACE is pleased to offer three systems to meet your exacting specifications.
Pages:
1
 |
IR 1000 SMT Rework Station The IR 1000 is a remarkably flexible and effective rework system at a price point that cannot be beaten! It is ideal for applications where variability in the work is common as well as for applications where the same work is being performed over and over and through-put is important. |
 |
|
 |
ST 300 Low Cost Hot Air Reflow System The ST 300 can be used to remove any SMD and for installing components with a limited number of leads that can be positioned manually. Rework Nozzles sold separately, |
|
|
 |
ST 325 Digital Programme Hot Air Reflow System The ST 325 is a digital, self-contained system that is fully programmable and can be used to remove or install surface mount components when individual or multiple operations are to be run. From the front panel, the system can be used in either manual or "timed" modes. Rework Nozzles sold separately, |
|
|
 |
ST 350 Convective Rework Center The ST 350 is the ultimate in cost effective, programmable, convective rework equipment. No other system on the market at the same price level can compete! Rework Nozzles sold separately, |
|
|
 |
ST 400 Radiant Pre-Heater The ST 400 is an analog, closed loop, temperature controlled radiant 400 W pre heater. The heating area is 140mm x 140mm (5.5" x 5.5"). This preheater is ideal for heavy PCBs and for area array applications as the medium wave IR delivers the most penetrating and even heating available. |
|
|
 |
ST 450 Convective Pre-Heater The ST 450 is an analog, closed loop, temperature controlled convective 1500 W preheater. The heating area is 140mm x 140mm (5.5" x 5.5"). This preheater is ideal for applications where focused hot air is desirable or where cooling air is required after the application of heat such as area array applications. |
|
|
 |
ST 500 Adjustable Z-Axis Platform When using convective hand tools, such as the ST 300 and ST 325, it is often helpful to place the handpiece into a fixture that has the ability to control the z axis movement when trying to align or place a component. |
|
|
 |
ST 525 12" If you prefer your work to be angled, use two long legs in the back and 2 short legs (supplied) in the front! These fixtures are ideal for prep-work, cutting leads, soldering, desoldering, inspection, and testing. |
|
|
 |
ST 550 18" If you prefer your work to be angled, use two long legs in the back and 2 short legs (supplied) in the front! These fixtures are ideal for prep-work, cutting leads, soldering, desoldering, inspection, and testing. |
|
|
